miles41

During a house clearance, I have gained a heater, which was still connected to the pond at the house; the owner had left it and just hope there aren't any Koi still in the pond.....can't see any as it's full of weed!

Anyway, the heater unit in question is an 'Elecro 900 series' heater, rated at 2kw, complete with timer and digital temp display. I have tested it and all works
I have given it a good clean out and is ready for re-use.

I was just wondering if anyone else had ever used these heaters? and is the installation relatively straight forward?
I have obtained a manual from the company's website Elecro Engineering - The Water Heating Specialist
and seems ok!

Any hints or tips would be appriciated. Cheers guys!

trickydicky

Miles i wouldnt use it as there rubbish...
I will however take it off your hands for £50 and give it a nice home
Seriously there pretty straight forward to fit infact markf1fan is gonna be fitting his later in the year i think

koimaster

i have a electro 3kw heater on my pond installation is very straight forward screw fit two end and make should the flow switch is the correct way around and bingo your cooking with gas or electric shall i say

markf1fan

hiya
i have one also and will be fitting it in the summer for winter, they look so easy like koimaster says. all you got to do is make sure the flow switch is the right way round. mark

__________________
1x 2400 gallon pond
1x estro sieve
1x econo bead filter
1x bakki shower with crystal bio
1x 55w pro clear uv
1x eco 12,000
1x sequence 15,000
1x hi blow 40 air pump
and some really nice koi

miles41

Sorry tricky...I shall be keeping it
Thanks for the replies.....I too shall be fitting it when the weather improves

Shevyrabbit

Hi Miles
There ok as long as it's under 3kw mine is 6kw and it was a nightmare to install you will need a new supply with me a complete new fuse box so hope it's under 3kw then you can just plug it in.

Shevyrabbit